Four-Bay Lff Hot-Plug Drive Backplane - HP ProLiant DL60 Gen9 Maintenance And Service Manual

Remove the non-hot-plug drive backplane.
7.
To replace the component, reverse the removal procedure.

Four-bay LFF hot-plug drive backplane

To remove the component:
Power down the server (on page 27).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend or remove
3.
Remove the access panel
4.
Remove all hot-plug hard drives
5.
Disconnect all cables connected to the drive backplane.
6.
Remove the hot-plug drive backplane.
7.
("Remove the server from the
("Access panel" on page 37).
("Hot-plug
rack" on page 30) the server from the rack.
drive" on page 36).
Removal and replacement procedures 39