WARNING! Read and understand the contents of this manual before attempting to service
WL200. Failure to follow the instructions in this manual could result in death, serious personal
injury, or severe property damage. Only trained and qualified technicians should attempt to
install, maintain, or service Waterlogic Equipment.
1. Visually inspect all electrical and water connections for signs of wear or damage.
DANGER! HIGH VOLTAGE ELECTRICAL HAZARD. Unplug before inspection and service.
2. Ensure there is adequate (minimum of 2") clearance around the unit and clean the condenser grill
and compressor fan to provide efficient cooling system operation.
3. Sanitize the cold tank per instructions in the pre‐installation procedures.
4. Clean and sanitize external surfaces of the unit. Use soap and water or chemicals that are
compatible with ABS plastic and will not damage or degrade the product surfaces.
5. Remove and clean the Faucet. Replace as needed.
WARNING! SANITIZER MAY CONTAIN HAZARDOUS CHEMICALS. Use of proper personal
protective equipment such as rubber gloves and eye protection is required.
WL200 Operating, Installation, and Service Manual Page 20 ‐ Revision: 4‐13‐2016
SERVICE REQUIREMENTS