Yamaha Montage 7 Reference Manual page 138

Reference
Performance
Mod/Control (Modulation/Control)
Part LFO
Same as the Element Common Edit parameters for Normal Parts (AWM2)
setting values of the Destination parameter differ and that "Element Phase Offset (LFO Element Phase
Offset)" is not available. For details on the setting values, see the Data List PDF document.
2nd LFO
[PERFORMANCE]  [EDIT]  Part selection  ELEMENT/OPERATOR [COMMON] 
Operation
[Mod/Control]  [2nd LFO]
LFO Wave (2nd LFO Waveform)
Selects the 2nd LFO waveform.
Settings: Triangle, Saw Down, Saw Up, Square, Sine, S/H
NOTE When "Sine" is selected, two waves will be shown in the diagram on the display because of the phase shift of
the Amplitude Modulation wave.
Key On Reset (2nd LFO Key On Reset)
Determines whether or not the 2nd LFO is reset each time a note is pressed.
Settings:
Off, On
Speed (2nd LFO Speed)
Adjusts the speed (frequency) of the 2nd LFO variation.
Settings:
0 – 99
Phase (2nd LFO Phase)
Determines the starting phase point for the 2nd LFO Wave when it is reset.
Settings: 0°, 90°, 180°, 270°
Delay (2nd LFO Delay Time)
Determines the delay time between the moment you press a key on the keyboard and the moment the 2nd
LFO comes into effect.
Settings: 0 – 99
MONTAGE Reference Manual
Edit
Normal Part (AWM2) Drum Part
(2nd LFO Pitch Modulation Operator Depth Ratio)
Amplitude Modulation Operator Depth Ratio
(2nd LFO Amplitude Modulation Operator Depth Ratio)
Search Utility
Normal Part (FM-X)
(page 85), except that the
Pitch Modulation Operator Depth Ratio
Live Set
Common/Audio
Normal Part (FM-X) Edit
Common
Part Settings
General
Algorithm
Zone Settings
Zone Transmit
Pitch / Filter
Pitch
PEG/Scale
Filter Type
Filter EG
Filter Scale
Effect
Routing
Ins A
Ins B
EQ
Arpeggio
Common
Individual
Advanced
Motion Seq
Common
Lane
Mod / Control
Part LFO
2nd LFO
Control Assign
Receive SW
Operator
Form / Freq
Level
138