Top Margin To First Line <Tsp100Eco Only - Star Micronics TSP100IIILAN Software Manual

■ Paper width used
The default setting is "80mm (Do Not Compress)".
By changing the setting to 80mm->58mm, the printing area is compressed widthwise so that 58 mm
width roll paper can be used instead of 80 mm width roll paper.
1) If the printing width is set to 51 mm using General Settings in the configuration
utility, the 80mm->58mm setting in Paper width used is disabled.
2) When Paper width used is set to 80mm->58mm, the barcode will be aligned on the
left margin of the paper when printed. If the printed barcode will be wider than
80mm->58mm, the barcode data will not be printed.
■ Receipt length reduction <TSP100ECO only>
The default setting is Original (no reduction).
The printing area can be compressed 50% reduction or 25% reduction lengthwise.
Because the size of printed barcodes is not reduced even if the receipt length
reduction settings are selected, the receipt length will be longer than the length for the
reduction ratio when printing data that contains barcodes.
4.5.2. Top Margin to First Line <TSP100ECO only>
The length from the leading edge of the paper to the first line of printing can be specified.
92
Software Manual