Adding A Printer - Star Micronics TSP100IIILAN Software Manual

4.7.1. Adding a Printer

● When no control object is registered:
"Not Selected" is selected in the 'Control Object Registration' field.
(1) Click "Add New".
(2) The following dialog box appears. Enter the name of the printer to be added, select the print
width and click "OK".
■ 180dpi compatible mode
When 180dpi compatible mode is checked, the left and right margins are automatically
adjusted.
(3) The printer is added, and "OPOS CCO (OPOS common control object)" is selected in the
'Control Object Registration' field.
Click "Apply Changes" to register the new printer device.
Notes: 1) The print width must match between the setting above and general settings (refer to
"4.3.2 Print Width in General Settings"). If they do not match, the print width
specified in general settings is automatically changed to the setting above.
2) The print width can be specified only when a printer is added.
To change the selected setting value, delete the device, and re-execute the steps to add
a printer.
101
Software Manual