Code Printing Function (2D Code Fonts); Entering A 2D Code Font (Qr Code) - Star Micronics TSP100IIILAN Software Manual

3.6. 2D Code Printing Function (2D Code Fonts)
The 2D code printing function performs QR code or PDF417 printing using device fonts supported in
this driver.
QR code or PDF417 printing is realized with a combination of 2D code fonts
("QR_CNTL", "PDF417", "DATA1", "DATA2", and "DATA3") and control fonts ("ESC_FONT"
and "ESC_FONT_KANJI").
Each Font Function as follows;
Device Font
Name
QR_CNTL
PDF417
DATA1
DATA2
DATA3
ESC_FONT

3.6.1. Entering a 2D Code Font (QR Code)

Follow the steps below to describe a QR code.
(1) 2D code type setting
Only describe the parameters to be changed because the default value is set to each setting
item.
(2) 2D code data setting
Describe parameters and 2D code data following a 2D code data setting command.
(3) Obtaining 2D code expansion information (Option)
An error notification will be returned if any inconsistencies are detected in the settings made
in steps (1) and (2).
(4) 2D code printing
For information about commands, refer to the separate manual, "STAR Line Mode Command
Specifications".
Example: When generating a 2D code of "012345ABCD " with a QR code (correction rate:
25%):
Function
Setting Output commands for QR
QR commands printing.
Setting
Output commands for PDF417
PDF417
printing.
commands
\x20 - \x7F replace \x00 - \x5F
\x20 - \x7F replace \x60 - \xBF
Setting
\x20 - \x5F replace \xC0 - \xFF
2D code data
Output \x20 - \x7F
58
Details
Output \x00 -\xFF
is possible.
Output \x20 -\x7F
is possible.
Software Manual
Memo