Williams Sound Digi-wave DLT 100 Manual page 11

Hide thumbs Also See for Digi-wave DLT 100:
Table of Contents

Advertisement

simultaneous interpretation setup
steps
roles
display
1. Interpretation Mode Setup
2. Master / Slave Setting
3. Transmitting Channel
Setting
4. Group Setting
5. Time Setting
6. Save and exit setup
12
main speaker (floor)
master
Main speaker's speech will be
Interpreters can be set as
transmitted through channel 0
many as needed. (1-14
channels: Max 14)
Press No - Yes buttons together for 2 Sec to enter setup menu. Then set to interpretation mode
Press menu button once, then press + or - button to set Master or slave (
NOTE: Master set to main speaker except when repeater is used. The first repeater must
be set to Master, then all other repeaters should be set to Slave.
Channel 0 is assigned
Press mode button once, then press + or - button to select transmitting channels of
automatically
interpreters (Interpreters: 1-14 Ch / Repeater: 0-14 Ch )
Press menu button once, then press + or - button to select group number between (0-1023). NOTE: Only one group possible in SI mode.
Press menu button once, then press + or - button to set current time (only Master / main
speaker has the ability to control time setting)
When setup is complete, press No - Yes buttons together to save and exit
interpreter
repeater
(SLV)
1 repeater per channel. (0-14
channels; max 15)
attendees
(DLT or DLR) receive only
Within a group, capable of
selecting one preferable
interpretation channel
(0-14 channels: Max 15)
. Press + or – button to select.
or
)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Digi-wave DLT 100 and is the answer not in the manual?

This manual is also suitable for:

Digi-wave dlr 50

Table of Contents