Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Williams Sound Digi-Wave DLR-50
Summary of Contents for Williams Sound Digi-Wave DLR-50
- Page 1 Digi-Wave DLR-50 ™ Digital Receiver user guide MAN156D...
-
Page 2: Operating Instructions
DLR-50 Digital Receiver Operating Instructions Compatible with WSC DLT-100 only. 1. Two AAA batteries must be inserted into the DLR. Be sure to observe correct polarity. 2. Power on/off by holding the power button for 2 seconds. 3. In interpretation mode, DLR will seek an active DLT. Press the channel button up or down to seek the next active DLT. -
Page 3: Button Functions
DLR-50 Digital Receiver 11. Low battery indicator will show as LO on the display. 12. The DLR will automatically power down after 1 minute if not synched with the DLT. Button Functions EXTERNAL HEADPHONE JACK (3.5MM MONO OR STEREO) VOLUME UP CHANNEL UP CHANNEL DOWN POWER ON / OFF... -
Page 4: Safety Information
DLR-50 Digital Receiver Safety Information HEARING SAFETY CAUTION! This product is designed to amplify sounds to a high volume. To protect your hearing and the hearing of others: 1. Make sure the unit is OFF or the volume is turned down before putting on the earphones. -
Page 5: Specifications
*Depending on environmental conditions NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE Recycling Instructions Help Williams Sound protect the environment! Please do not dispose of equipment or used batteries in the household trash. Take the equipment to an electronics recycling center or return to the factory. -
Page 6: Limited Warranty
DLR 50 RECEIVER, INCLUDING BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. WILLIAMS SOUND SHALL NOT BE LIABLE TO ANY PERSON OR ENTITY FOR ANY MEDICAL EXPENSES OR ANY DIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES CAUSED BY ANY USE, DEFECT, FAILURE OR MALFUNCTION OF THE PRODUCT. - Page 7 DLR-50 Digital Receiver This device complies to “RSS-Gen Issue 2 June 2007” for Industry Canada and FCC part 15.105(b) for the United States. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
-
Page 8: Customer Service
Attn: Repair Dept. 10300 Valley View Rd. Eden Prairie, MN 55344 10300 Valley View Rd • Eden Prairie, MN 55344 800-328-6190 / 952-943-2252 • FAX: 952-943-2174 www.williamssound.com Printed in the USA · ©2012 Williams Sound · All Rights Reserved. MAN156D...
Need help?
Do you have a question about the Digi-Wave DLR-50 and is the answer not in the manual?
Questions and answers