Table of Contents
Advertisement
Quick Links
Visit us online at
www.uswatersystems.com
Greenwave Plus Salt-Free Water Conditioner
Owners Manual
Models:
385--GWP-1000-UV, 385-GWP-1500-UV, 385-GWP-2000-UV
REVISION #
1.3
REVISION DATE
May 5, 2015
Visit us online at www.USWaterSystems.com
US Water GreenWave Plus Salt-Free Water Conditioner | 385-GWP
US Water Systems Corporate Office
1209 Country Club Road
Indianapolis, IN 46234
Give us a call at: 1-800-608-8792
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for US Water Systems Greenwave Plus 385-GWP-1000-UV
Summary of Contents for US Water Systems Greenwave Plus 385-GWP-1000-UV
- Page 1 US Water GreenWave Plus Salt-Free Water Conditioner | 385-GWP Greenwave Plus Salt-Free Water Conditioner Owners Manual Models: 385--GWP-1000-UV, 385-GWP-1500-UV, 385-GWP-2000-UV US Water Systems Corporate Office 1209 Country Club Road REVISION # Indianapolis, IN 46234 REVISION DATE May 5, 2015 Visit us online at www.USWaterSystems.com...
-
Page 2: Unpacking Inspection
Be sure to check the entire system for any shipping damage or parts loss. Also note damage to the shipping cartons. Contact US Water Systems at 1-800-608-8792 or visit www.uswatersystems.com/returns to report any shipping damage within 24 hours of deliv- ery. - Page 3 US Water GreenWave Plus Salt-Free Water Conditioner | 385-GWP Introduction The GreenWave system provides protection from scale formation throughout the home. The GreenWave system can be installed at the point-of-entry to treat your entire home, both hot and cold water, or it can be located directly before a water heater or other device (e.g.
-
Page 4: Proper Installation
US Water GreenWave Plus Salt-Free Water Conditioner | 385-GWP Proper Installation This water conditioning system must be properly installed and located in accordance with the Installation Instructions before it is used or the warranty will be void. Do not install or store where it will be ex- posed to temperatures below freezing or ex- posed to any type of weather. - Page 5 US Water GreenWave Plus Salt-Free Water Conditioner | 385-GWP An Important Note about Iron, Manganese & Copper Iron and Manganese Just as with conventional water softening media, GreenWave needs to be protected from excess levels of certain metals that can easily coat the active surface, reducing its effectiveness over time.
-
Page 6: Equipment Specifications
US Water GreenWave Plus Salt-Free Water Conditioner | 385-GWP Equipment Specifications GreenWave systems are complete, self-contained, loaded with media and ready to use. A simple inlet and outlet connection is all that is required for installation. Please review operating pressures, temperatures and water chemistry limitations to ensure compatibility. Specifications Inlet/Outlet Connection 3/4”... - Page 7 US Water GreenWave Plus Salt-Free Water Conditioner | 385-GWP UV Light Equipment Specifications This point-of-use system allows for simple installation and operation due to its high output lamp and compact reactor. The reactor is an axial flow design with superior hydraulics, com- pact design and 1”...
- Page 8 UV Light Equipment Specifications Operation The US Water Systems UV comes with a feature laden controller that incorporates both the lamp driver (ballast) and control features in one water-tight case. CAUTION: Prior to performing any maintenance on your UV system, you must always disconnect the power.
- Page 9 US Water GreenWave Plus Salt-Free Water Conditioner | 385-GWP UV Light Equipment Specifications USWATER 5.0 & USWATER 6.0 Power-up Sequence Upon start up, the 5.0 & 6.0 controller will run through a diagnostic start-up and the sequence will be displayed as follows on the color LCD: Next, the controller checks for the installation of any optional modules that may be installed on the system.
- Page 10 Screen.
- Page 11 US Water GreenWave Plus Salt-Free Water Conditioner | 385- UV Light Equipment Specifications USWATER 6.0 Operational Screens On systems that have the UV module installed (and on all USWATER6.0 systems), the default screen shows the % UV Intensity. At any point during operation the user is able to scroll through the % UV Intensity, Lamp life remaining an d QR Code s c r een s b y s i m p l y p r es s i n g t h e b u t t o n l o c at ed on the front of the controller.
- Page 12 US Water GreenWave Plus Salt-Free Water Conditioner | 385- UV Light Equipment Specifications Once the UV output drops below 56%, the numbers and warning sign switch to red and a 15 second intermit- tent audible chirp is given off by the ballast. When the output drops below 51%, the display switches to a solid red and a constant audible signal is provided.
- Page 13 USWATER5.0 & USWATER6.0 Failure Modes The US Water Systems controller continuously monitors your UV system and if there is a problem with the system the controller will provide both a visual and audible signal indicating the specific fault that may be adversely affecting the operation of your system.
- Page 14 Users with a camera phone equipped with the correct reader application can scan the image of the QR code and over a wireless network connect to a US Water Systems web page in the phone's browser. US Water Systems' QR webpage has information on how to purchase replacement components as well as a helpful video directory on system servicing (i.e.
-
Page 15: System Overview
US Water GreenWave Plus Salt-Free Water Conditioner | 385- System Overview US Water UV Filter Housing GreenWave GreenWave NAC Carbon Tank Heads Media Tanks The Carbon Tank will be about 75-90% full of car- bon. The NAC Tank will have just a few inches of me- dia in the bottom of the tank. - Page 16 US Water GreenWave Plus Salt-Free Water Conditioner | 385- System Overview (Configuration) UV Ballast US Water UV Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792...
-
Page 17: Micron Sediment Filter Installation Instructions
US Water GreenWave Plus Salt-Free Water Conditioner | 385- Filter Housing Installation 5 Micron Sediment Filter Installation Instructions 1. Install the 5 Micron sediment filter first. This filter should be installed at the point of entry of the home. The sediment filter is marked “IN” and “OUT” on the top of the housing. 2. - Page 18 US Water GreenWave Plus Salt-Free Water Conditioner | 385- Filter Housing Installation 3. Now mount the filter housing to the wall using the appropriate fasteners for your wall materi- al. It is preferred that this is mounted on a secured board or wall stud as it will be heavy when full of water.
-
Page 19: Sediment Filter Installation
US Water GreenWave Plus Salt-Free Water Conditioner | 385- Sediment Filter Installation 1. Now install the filter in the filter housing by removing the sump from the housing. 2. There is a notch in the bottom of the sump that will center the filter in the housing. Unwrap the filter (5 Micron) and install it in the sump. - Page 20 US Water GreenWave Plus Salt-Free Water Conditioner | 385- Sediment Filter Installation 4. Now install the sump in the filter cap and turn it clockwise to tighten the filter. Once it is hand tight, use the supplied wrench to tighten it an additional 1/4-1/2 turn. 5.
- Page 21 US Water GreenWave Plus Salt-Free Water Conditioner | 385- Carbon Tank Installation 1. Make sure that the distributor tube (shipped inside the tank) is centered in the indent in the bottom of the tank (use a flashlight if necessary). (Figure A). 2.
- Page 22 US Water GreenWave Plus Salt-Free Water Conditioner | 385- Greenwave Tank Installation 1. Place the GreenWave tanks in the desired location on a flat level surface. The NAC tank is pre-filled with media. The carbon tank was previously filled with media and water on page 13. 2.
- Page 23 US Water GreenWave Plus Salt-Free Water Conditioner | 385- US Water UV Light Installation Figure 3. Recommended Installation Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792...
- Page 24 Step 4: If the water supply flow rate is unknown, it is recommended that you use a flow restrictor so that the rated flow of your particular US Water Systems system is not exceeded and the UV dose is not compromised.
- Page 25 US Water GreenWave Plus Salt-Free Water Conditioner | 385- US Water UV Light Installation Step 9: You can now gently remove the quartz sleeve from its packaging being VERY careful not to touch the length with your hands. The use of cotton gloves (not included) is recommended for this procedure as oils from our hands can leave residue on the sleeve and lamp which can ultimately block the UV light from getting to the water.
- Page 26 US Water GreenWave Plus Salt-Free Water Conditioner | 385- US Water UV Light Installation Figure 5. UV Sensor Installation Figure 6. IEP Connection Step 12: Th e r eac t o r i s n ow read y f o r w at er f l o w . Wh en al l p l u m b i n g c o n n ec t i o n s h av e b een completed you should check for any possible leaks.
- Page 27 US Water GreenWave Plus Salt-Free Water Conditioner | 385- US Water UV Light Installation Figure 7. UV Lamp Connection Step 15: Carefully insert the UV lamp into the reactor sliding it inside the quartz sleeve located in- side the reactor (do not drop the lamp into the reactor). Affix the lamp connector into the gland nut by in- serting the connector into the nut and turning the connector approximately ¼...
- Page 28 US Water GreenWave Plus Salt-Free Water Conditioner | 385- US Water UV Light Installation Figure 9. Ground Screw Connection Step 17: Your system is now ready to be plugged into the appropriate GFCI protected outlet . The unit will be plugged in during the startup procedure. DO NOT plug in at this time. Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792...
-
Page 29: Engineering Specifications
US Water GreenWave Plus Salt-Free Water Conditioner | 385- Start Up 1. Make Sure that the NAC Tank is on “bypass” - shown at the right. 2. Slowly open the supply valve (user supplied) to the GreenWave Carbon Tank or slowly open the Carbon Tank Bypass valves. -
Page 30: A Note To The Homeowner
US Water GreenWave Plus Salt-Free Water Conditioner | 385- A Note to the Homeowner Your GreenWave system will improve the properties of water throughout your home. Here are some things to expect and some recommendations for maximizing the benefits and your enjoyment of your GreenWave system. - Page 31 6. Information, including model number, serial number, and date of installation, must be provided for any claims pertaining to equipment in warranty. 7. Defective parts are subject to inspection by either US Water Systems, Inc. or any authorized representative before final commitment of warranty adjustment is made.
- Page 32 US Water GreenWave Plus Salt-Free Water Conditioner | 385- Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792...
-
Page 33: Limited Lifetime Warranty
GreenWave Plus This warranty does not apply to any commercial or Water Conditioning System, US WATER SYSTEMS, INC. industrial installations or to any part of the water conditioner which has been subjected to misuse, neglect, warrants the following: alteration or accident;...
Need help?
Do you have a question about the Greenwave Plus 385-GWP-1000-UV and is the answer not in the manual?
Questions and answers