Rods And Forks - Alfa Romeo alfa 33 Workshop Manual

4. Remove pin @ inserted into
flexible support @ and remove the
flexible support itself from rear
support should its replacement be
required.
1 Pin 2 Flexible support
5. Unscrew screws connecting flex-
ible supports @ and @ to rear
Remove flexible supports.
3 Lower flexible
1 Rear caver
2 Upper flexible
support
support
CAUTION:
ûearbox casing is made of aluminium
Handle with maximum tare to avoid
damaging it.
CHECKS AND INSPECTIONS
1. Clean metal parts of rear support
tegrity.
2.
lation wear.
3 . Check o n i n t e g r i t y o f r u b b e r
b u s h i n g s , a n d r e p l a c e w o r n o r
damaged ones.
GEARBOX
ASSEMBLY
Reassemble end flexible support
on rear support, the pair of flexible
supports on rear caver, then the rear
support itself following the reverse
order for disassembly and using the
2.
gearbox on rear support (refer to:
Gearbox Outer Linkage - Assembly).

RODS AND FORKS

DISASSEMBLY
1. Remove spring pin securing lever
to main selector rod 0 and remove
lever.
1 Main selector rod 2 Lever
2. Unscrew reverse
with relevant washer from rear cov-
0
er 2 .
1 Switch
1 3 - 6
3 . U n s c r e w s c r e w @ a n d r e m o v e
plate @ securing oil bleeder valve
to gearbox casing caver and remove
valve plug @ and valve aitself.
1 Valve plug
2
4. Unscrew and remove screws @
f i x i n g r e a r caver @ to g e a r b o x
casing @ . Use a plastic hammer fo
loosen caver and remove it together
with seal gasket @.
gear
1 Screws
2 Rear caver
3 Plate
4 V a l v e
3 Gearbox casing
4 Seal gasket