Alfa Romeo Giulietta 2.0 JTDM Manual

Alfa Romeo Giulietta 2.0 JTDM Manual

Radio navigator with maps

Advertisement

191 - Giulietta 2.0 JTDM INTRODUCTION - RADIO NAVIGATOR WITH MAPS
RADIO NAVIGATOR WITH MAPS
The radio navigator module, located in the middle of the dashboard, includes:
- radio module with dual aerial and dual tuner;
- Audio CD and CD MP3 player;
- SD card reader;
- GPS module;
- independent navigation module with maps;
- "flap display" TFT 6.9", motor-driven, on the top middle part of the dashboard;
- interface with the controls on the steering wheel.
The RADIONAV system described below comes in two versions:
- matched with the "basic" radio: there is no telephone management: the navigation functions are managed by the RADIONAV and shown by
maps on the display.
- combined with the "Blue&Me": in this case the RADIONAV manages navigation and Blue&Me manages the Media Player and Bluetooth
mobile functions.
Example of main MENU screen:
Audio module
General specifications:
- 5 predefined band graphic equalizer;
- easily operated menu for adjusting radio settings or any outside interfaces (Media Player);
- remote control from the steering wheel;
- speed-dependent volume control.
Radio tuner specifications:
- RDS
- RDS - TMC (Traffic Message Channel)
- EON (Enhanced Other Network)
- TA (Traffic Announcements)
Tuning of the following bands: USW (87.5-108 MHz) (FM); MW (153-279 kHz) (AM); LW (531-1602 kHz) (AM);
Possibility of storing:
- 18 FM stations (6 of which can be memorised through autostore);
- 12 FM stations (6 of which can be memorised through autostore);
2 scan modes (brief playback of one station and automatic scan to the next):
- scan on the frequency band used and stations memorised.
- possibility of selecting programmes via PTY (on FM bands only).
(RadioNAV)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Giulietta 2.0 JTDM and is the answer not in the manual?

Questions and answers

Summary of Contents for Alfa Romeo Giulietta 2.0 JTDM

  • Page 1 191 - Giulietta 2.0 JTDM INTRODUCTION - RADIO NAVIGATOR WITH MAPS (RadioNAV) RADIO NAVIGATOR WITH MAPS The radio navigator module, located in the middle of the dashboard, includes: - radio module with dual aerial and dual tuner; - Audio CD and CD MP3 player;...
  • Page 2 - predefined sensitivity such as distant. - List function which shows the list of all radio stations available Example of screen with radio activated: AUDIO SPECIFICATIONS: - bass / treble - fader / balance - loudness - hi-fi system active control - 5 predefined equalizer curves: - predefined (manufacturer's equalizing);...
  • Page 3 1. Device Code (it can be obtained as follows): A. Press the MENU button to enter the navigation system menu. B. Turn the right knob, select "CONFIGURATIONS" and press the knob to confirm. C. In the menu, select the "SD CARD - MEDIA AND MAPS" option. D.
  • Page 4: System Operation

    1. Click on "Register" in top right corner; a screen for entering personal details, such as name, address and e-mail address for future activations is displayed. Please note that the e-mail address is not compulsory, but is should be given to receive activation codes by e-mail. - The fields marked by an asterisk "*"...
  • Page 5 - Polish. Navigation The radio navigator makes location of the vehicle and route guidance possible. Location takes place via: - GPS satellite location; - Dead reckoning; - Map matching. GPS location: this refers to location through the reception of GPS signals; at least three satellites should be received via the dedicated aerial mounted on the vehicle roof.
  • Page 6: Traffic Info

    The system calculates the optimum route for reaching the place or places set and a route with one of the following priorities can be set: - quickest - shortest - best distance/time ratio - motorway yes/no - ferries yes/no - RDS TMC yes/no. Possible information from radio navigator during navigation Example of screen for NAV application during navigation: Car location information:...
  • Page 7 By selecting the dna item from the main menu it is possible to access the mode screen that highlights (possibility of selection) the item corresponding to the actual position of the switch. Selecting the item relating to the dna mode makes it possible to access the information screen that shows the vehicle setting divided between Handling and Engine areas in relation to the selection mode.
  • Page 8: Dynamic Display

    - SD Card management: contains several items relating to the removal and management of the map SD card. - SD card safe removal: allows the procedure for the safe removal of the SD card to be activated. - Navigator serial number: allows the display of the radio navigator serial number necessary for the map activation procedure. - Map licence activation: selecting this item gives access to the screen for entering the map activation code.
  • Page 9: Media Player

    Mediaplayer The radio navigator reproduces musical tracks memorised on a digital device through the on board audio and stereo system: USB drive, MP3 player. When the device is connected to the USB port, the radio navigator display shows that the Media Player is activated and the music information is available in the "MUSIC"...
  • Page 10 Radio Mode: scanning function to search for the first audible radio station with frequency lower/higher than the starting one (FM or AM 3 - 4 mode) CD - CD/SD MP3, Media Player mode: select next/previous track Map Mode: scroll map to the left/right Radio mode: frequency decrease (FM or AM mode) MP3 CD/SD mode: select previous folder...
  • Page 11: Steering Wheel Controls

    A - Display angle adjustment B - Display opening/closing Steering wheel controls The controls for the main radio navigator functions are replicated on the steering wheel to make things easier. Button Short button press (less than 2 seconds) Long button press (more than 2 seconds) Activate Telephone and Menu functions (if Blue&Me is present) Activates/deactivates Audio functions...
  • Page 12 The rear view of the radio navigator with the connectors highlighted is illustrated below. Connector A SIGNAL Right rear speaker (positive) Right front speaker (positive) Left front speaker (positive) Left rear speaker (positive) Right rear speaker (negative) Right front speaker (negative) Left front speaker (negative) Left rear speaker (negative) Outside display power supply...
  • Page 13 Aux R signal (MP right) from Bluetooth control unit Outside display backlighting control PWM signal Video signal (CVBS signal) from outside TV camera (N.C.) D- signal (USB differential data signal) from USB port (N.C.) Power supply (USB device power supply) for USB port (N.C.) Signal from hands-free microphone (N.C.) Aux L signal (MP left) from Bluetooth control unit Aux GND reference earth (MP GND) from Bluetooth control unit...
  • Page 14 Earth reference for display Display power supply Digital output signal for open display PWM signal for display backlighting Earth reference for display...

Table of Contents

Save PDF