Rear Combination Lamps - Alfa Romeo alfa 33 Workshop Manual

A = distance of headlight centre
from ground
= height of luminous beam
C = IO m (32,8 ft)
Orientation is correct when the
following condition occurs:
Distance D between luminous

REAR COMBINATION LAMPS

REMOVAL AND
INSTALLATION
With reference to the exploded view,
operate as follows.
Open back door and lift rear
trim.
2.
Disconnect connector.
3 .
Unsaew the six nuts securing
combination lamps to body, then
remove combination lamps.
ELECTRICAL SYSTEM
centre must be equal to distance E
between headlight center.
The dimensions indicated in the
diagram comply with provisions in
force in Italy. For other countries,
comply with national provisions.
For correction of possible orien-
ment inside, operate on adjusting
beams
screws of headlights set in evidence
in the following figure.
1 Combination lamps
2 L a m p
3 Lampholder
4 0 - 1 9
1 Horizontal direction adjustment screw
2 Verrical direction adjustment screw
4.
For installation of combination
lamps, reverse order of removal.
LAMP REPLACEMENT
The following procedure is applicable
to all lamps and lampholders.
M a y 1 9 8 3