Check Control And Trip Computer - Alfa Romeo alfa 33 Workshop Manual

LOCATION

Check Control and Trip Computer

are inserted into a special instrument
holder integrated into gear lever
console, in centre position, under
dashboard.
REMOVAL AND
I N S T A L L A T I O N
1. Withdraw instrument holder 3
from console and disconnect the
relevant harness.
2. Remove Check Control 2 and
Trip Computer 1 by unscrewing,
for each one, the two securing screws
to instrument holder.
2 Check Control
1
lstantaneous consumption in L/100 km
Medium consumption for the covered distance in L/100 km
2
starting from zeroing by red Key (Start Key)
Fuel consumption in litres since trip start, starting from
3
zeroing by red Key
4 Medium speed in km/h since trip start, starting from
zeroing by red Key
5 Drive time in h/min since trip start, starting from zeroing
by red Key
Time in hoursjmin
6
May 1983
ELECTRICAL SYSTEM
3. For instrument installation, re-
verse order of removal.
When reading a red led
For an easier comprehension of the
symbology used for the two instru-
ments, in the following table refer-
Trip Computer
used to set in evidence the enabled
function in order to allow user an
easy identification.
diode is
Indications and the Check Control
signallings, pairing them to relevant
symbols.
Check Control
Windscreen washer fluid level warning lamp
7
Engine oil level warning lamp
8
Engine coolant level warning lamp
9
10
Cluster warning lamp
11 Stop lights warning lamp
Side lights warning lamp
12
Main red warning lamp
13
Main green warning lamp
14