Installation - Alfa Romeo alfa 33 Workshop Manual

6. Fit washers on shaft, wheel side,
according to numbering marked at
time of disassembly. Now fit the
constant-speed joint with the help of
a press, of two half-plates and of tool
lubricating
7. Finish up
joint with 40 g (1.41 02) more of the
above mentioned grease and make
sure that balls are completely sur-
rounded by grease.
8. Fit boot on joint; fit new clamps
and tighten them using suitable pliers
being careful not to damage the boot
in doing so.
INNER JOINT (B)
Thoroughly coat with grease (Moly-
kote 2461 C or Optimal Olistamoly 2
the steel balls; pack the joint' s recess
with 40 g (1.41 02) of the same type
grease.
1. Fit boot on shaft being extreme-
ly careful not to damage it in any
DIFFERENTIAL AND DRIVE SHAFT ASSEMBLY
way along the splines; to this effect
splines should be covered with tape.
2. Following disassembly proce-
dure in reverse sequence, now fit the
inner race and the cage.
3. Fit steel balls as shown in the
figure and verify that the joint works
properly.
by packing
CAUTION:
Do not exchange this joint' s steel
balls with those of the outer joint as
their diameter is different.
4. Fit inner cover to the joint and
then fit the latter on the shaft with
the help of a press, of two half-
plates, of a base and a punch.
5. Pack joint with 40 g (1.41 02)
more of the above mentioned grease
and
make
completely surrounded
6. Fit both seal rings on the joint' s
outer ring.
sure
that balls are
by
grease.
7. Fit lock ring following disas-
sembly procedure
in reverse se-
quence.
8. Fit the boot; fit new clamps
tighten them using suitable pliers
being careful not to damage the boot
in doing so.
9. Fit the three plates to the inner
cover,
insert relevant screws and
and
washers, lastly fit the outer cover
onto the six screws.

INSTALLATION

1 . I n s e r t s h a f t i n t o w h e e l h u b .
2 . C o n n e c t s h a f t t o d i f f e r e n t i a l
drive shaft and lock securing screws
to specified torque.
33 -F 36 N-m
(3.4 + 3.7 kg-m
24.56 f 26.75 ft-lb)
new
3. By means of a nut, secure
wheel hub to shaft. Tighten nut to
specified torque, then
226 + 275 Ndrn
166.30 + 202.46
and
caulk it.
ft.lb)
May 1983