Vecow RCS-70000 User Manual page 34

The 10/100/1000 Mbps Ethernet LAN ports 1 and 2 use 8-pin RJ-45 connector.
LAN1 is equipped with Intel 82579LM for AMT function. LAN2 is equipped with
Intel 82574L.
Using suitable RJ-45 cable, you can connect RCS-7000 series system to a
computer, or to any other piece of equipment that has an Ethernet connection,
for example, a hub or a switch.
Moreover, both of them have Wake-on-LAN and Pre-boot Execution
Environment capabilities. The following diagram shows the pinouts for LAN1
and LAN2 port.
Pin No.
1
2
3
4
5
6
7
8
The Ethernet ports use standard RJ-45 jack connectors with LED indicators on
the front side to show Active/Link status and Speed status. The LED indicators
on the right bottom corners glow a solid green color when the cable is properly
connected to a 100 Mbps Ethernet network. The LED indicator on the left
bottom corner will flash on and off when Ethernet packets are being transmitted
or received.
The LED indicators on the right bottom corners glow a solid orange color when
the cable is properly connected to a 1000 Mbps Ethernet network. The LED
indicator on the left bottom corner will flash on and off when Ethernet packets
are being transmitted or received.
Location
Right Bottom LED
Left Bottom LED
10 / 100 Mbps
E_TX+
E_TX-
E_RX+
----
-----
E_RX-
-----
------
1
10 Mbps
off
Flash Yellow
GETTING TO KNOW YOUR RCS-7000
1000 Mbps
MDI0_P
MDI0_N
MDI1_P
MDI2_P
MDI2_N
MDI1_N
MDI3_P
MDI3_N
8
100 Mbps 1000 Mbps
Solid Green Solid Orange
Flash Yellow Flash Yellow
27