Satel INT-TSG User Manual page 9

SATEL
icon will display macro commands assigned to that group. Up to 16 macro commands can be
assigned to one group.
If macro commands are assigned only to one group, tapping the
macro commands at once. In the keypad with factory settings, two macro commands are
programmed and assigned to the first group (the figure below shows the screen to be
displayed on a keypad with factory settings).
The control panel will execute the factory programmed macro commands, provided
that the alarm system is suitably configured by the installer.
You should consult the installer about which additional macro commands would
facilitate operation of the alarm system or control of the home automation devices
connected to the control panel. Only the installer can program any additional macro
commands.
Icon Function
Quick full arming (without user authorization by using a code) – in a similar way
as after pressing the 0
Exit delay clearing – in a similar way as after pressing the 9
the keypad with text menu.
The keypad can be configured by the installer so as to start the function of output control
from the terminal on tapping the
may be required).
INT-TSG
keys on the keypad with text menu.
icon (tapping and holding the icon for about 3 seconds
icon will display the
keys on
7