Sewing A Single Built-In Design - ELNA EXPRESSIVE 820 Instruction Manual

Built-in Designs
Hoop Size A(F): 126 1 10 mm
X
1 2
5 6
Mode
Ready to Sew
Mode
1/14
3 4
A Z
7 8
A Z
Jog
ST
START
STOP
56

Sewing a Single Built-in Design

Select a design.
Touch "Return" key in the hoop size warning
message.
Hoop fabric and attach hoop to carriage. Position
needle directly over centerlines on fabric. Thread
machine with first thread color. Lower presser foot.
Press "Start/Stop" key and sew 5 or 6 stitches.
Stop machine by pressing "Start/Stop" key.
Raise presser foot. Cut away beginning thread tail
close to the start point. Lower presser foot.
Press the "Start/Stop" key and let the machine sew
until it stops automatically for the thread change.
If the auto thread cutter command is ON, the
machine will automatically cut the threads when
each color section is sewn.
See page 24.
Sew entire design using method described above
for each thread change.
When design is finished, the word "Completed" will
appear. Touch the "Return" key.
The design should be aligned with the centerlines
on the fabric.
HINT: You can check the design positioning before
sewing with the tracing key or template sheets.