Built-In Needle Threader - ELNA EXPRESSIVE 820 Instruction Manual

Built-in Needle Threader

Hand turn the flywheel (always turn towards you) to bring
the needle up to its highest position. Turn OFF the power
switch. Lower the presser foot.
q
Pull down the needle threader lever as far as it will go.
w
Hook is automatically inserted into the needle eye.
q
w
e w
Bring the thread around guide and under hook .
e
w
Slowly release the lever while holding the thread end and
let the needle threader return to its original position. A loop
r
of thread is pulled through the needle eye.
r
Pull the thread loop off the guide to the back and manually
bring the thread through the needle eye.
NOTE: The needle threader can be used with #11 to #16
size needles. Thread weight may vary from 30 to 90.
If the needle threader does not catch a thread loop, check
the needle and positioning.
38