Montigo PL42DF Installation & Maintenance Manual page 16

PL42DF* Indoor Gas Fireplace
45° Corner Installation.
Attach an PEL-45 (45° elbow) directly onto the flue collar. Cut the
PXT-20 to suit, and attach it to the PEL-45. Slide the fireplace into
position and attach to the termination.
Figure 15. Corner (Rigid) installation. (NG Models Only)
Page 16
Installation
45° or less Corner Installation.
Use an PTO-4 termination and an PFL-1 or PFL-2 (12" or 24"
compressed length) and a frame, if appropriate. Flex may be turned
to obtain desired degree of angle required but must not exceed 45°.
PXT-18
PEL-45 Elbow
PEL-90 Elbow
Figure 15a. Corner (Flex) installation. (NG Models Only)
Note: Through the wall venting kits are also available for both the
Straight and the Corner Installation. The Kit includes a heat shield,
a PFL-18 (f/f) flexible pipe, and a termination with or without a
mounting frame.
Note: Images are shown without screens for clarity purposes.
However, your fireplace should not be operated without proper
installation of screens.
Corner Installation is available for
PL42DF Top Vent Units Only. Ensure
minimum Vertical Venting Height of 48"
is maintained in corner installations.
IMPORTANT:
XG0217 - 160215.1