Ar7200Bx Default Blade 300 X Setup - BNF BLADE 300 X Instruction Manual

AR7200BX Default Blade 300 X Setup

SETUP MENU Menu LED solid
Status-LED:
A Mounting orientation
B
Swashplate servo—frequency
Tail servo—center position pulse
C
length
D
Tail servo—frequency
E Tail servo—rotor endpoints
F Tail—sensor direction
G Swashplate—servo centering
H Swashplate—mixer
I Swashplate—servo directions
Swashplate—cyclic pitch
J
geometry
K Collective pitch range
L Swashplate—cyclic limit
M Swashplate—sensor directions
N Pirouette optimization direction
PARAMETER MENU Menu LED is flashing quickly
Status-LED:
A
Swashplate—
cyclic center adjustment
B Control behavior
C Swashplate—pitching up
behavior
D Tail—HeadingLock gain
E Stick deadband
F Tail—torque precompensation IX)
G Cyclic response
H Pitch boost
*The AR7200BX included with your Blade 300 X helicopter is pre-programmed with these default settings. If you perform a factory reset on the included
AR7200BX will default back to these default Blade 300 X helicopter settings.
To perform a Blade 300 X AR7200BX factory reset, enter any Setup menu and press the setup button for 10 seconds. After performing the factory reset, you will
need to re-center the swashplate servos by using setup menu G.
If you update the firmware on the AR7200BX to non-Blade 300 X firmware: All Blade 300 X helicopter default settings will be deleted. You will need to
complete the entire AR7200BX setup process before flying the helicopter again. Please refer to the Spektrum AR7200BX instruction manual included
with your helicopter for more information.
EN
OFF Purple
User
50Hz
defined
User 960μs
defined
User 50Hz
defined
Tail stick—move to right endpoint and wait/left endpoint and wait
Reference ELE center
position pos.
User
mechanical
defined
nor|rev|rev nor|nor|rev*
Aileron stick–adjust 6° cyclic pitch on the roll axis (blades aligned with fuselage)
Collective stick on max and min position and use tail stick to adjust desired pitch.
Stock settings provide +/- 12 degrees of collective pitch.
Move aileron, elevator and pitch sticks – adjust max limits with tail stick
rev | rev rev | nor
OFF Purple
Aileron and elevator stick – reset with tail stick
User
normal
defined
User very low
defined
User very low
defined
User
1
defined
User off*
defined
User
normal
defined
User off*
defined
12
Red
Red Solid
Flashing
upright
(vertical)
65Hz 120Hz
760μs
165Hz 270*Hz
normal
AIL center
pos.
90° 120°*
nor|rev|nor
nor | rev
normal
Red
Red Solid
Flashing
sport pro
low medium*
low medium*
2* 3
low—nor high—nor
slightly increased
increased*
low medium
Firmware version 3003.0.0
Blue
Blue Solid
Flashing
flat
(horizontal)*
165Hz 200Hz*
1520μs*
333Hz 560Hz
reversed*
PIT center
pos.
140° 140° (1=1)
nor|nor|nor
nor | nor*
reversed*
Blue
Blue Solid
Flashing
extreme transmitter*
high very high
high very high
4 5
low—rev high—rev
high very high
high very high