Sfe (Special Feature Enablement) - Samsung MultiXpress M537x series Service Manual

4. Troubleshooting

4.5.6.14. SFE (Special Feature Enablement)

•
Service Functions > SFE
Special Feature Enablement (SFE) means to provide the configurable options (On/Off) in service mode for technicians or
dealers to satisfy the requirements from B2B sites easily without changing the firmware installed in a device.
NOTE
Some menus may not appear on the display depending on the model.
SFE menu description
SFE Title
Code
001 Letterhead/Preprinted paper handle
003 CCC mode
007 1 dot line compensation
008 Ignore paper size command
009 HPOS compatibility
010 Power Save Time Range
012 Deletion of Print Job in jam status
013 Ignore USB memory stick (Code :
013)
014 Fullfil default [TO] address of
authenticated user (Code : 014)
015 LDAPs get default form address after
Kerberos authentication
016 Full Image TCR Print
4-70
Description
If this option is enabled, in case of printing in directional media
(Letterhead/Preprinted), the device prints as the same output direction
regardless of simplex or duplex.
To meet CC(Common Criteria) confirmation, security function is changed to
the required specification from IEEE P2600.1.
If this option is enabled, the device prints as original 1 dot line without 2 dot
line compensation.
If this option is enabled, the device ignores paper size command in PRN and
prints as paper size in tray.
PJL readback response is changed with HPOS.
1) Add <CR><LF> to EOJ response.
2) No EOJ job but EOJ response occurs.
3) Device uses Job name instead of EOJ name.
If this option is enabled, maximum value of 'Power save time' is increased
as 240 min.
If this option is enabled, print job is deleted in jam status.
If this option is enabled, the device ignores the USB memory stick and detects
only card reader.
When the authenticated user uses scan to email, their email address is added
automatically.
Ths system should support to connect to LDAPs server without any certificate.
"When the system queries user's E mail information to LDAP server, the
system should use ""Kerrberos Authentication"" domain data. Namey, LDAP
Query should include domain data (DC=""Realm name or Domain name"")
from Kerberos Realm selected for authentication." "The system should get the
proper user E mail information according to Kerberos Domain information
eventhough there are LDAPs DB in the network.. (Ex. Default From Address)"
Supports Image Appearance to be printed with fit to report page. This SFE
option will be applied to "Send Confirmation" or "Fax Send Confirmation"
reports.
Enable : Image Apprearance fit to report page
•
Disable(default) : Image Apearance reduced on the half page.
•
Copyright© 1995-2013 SAMSUNG. All rights reserved.