Input System Failure #H1-2253 : Pull Hcf 2 Out And Insert It - Samsung MultiXpress M537x series Service Manual

Mono laser mfp
Hide thumbs Also See for MultiXpress M537x series:
Table of Contents

Advertisement

► Error Code
H1-2253
► Error message

Input System Failure #H1-2253 : Pull HCF 2 out and insert it.

► Symptom
The paper is not fed from HCF.
► Troubleshooting method
1) Turn the machine off than on.
2) If the problem persists, turn the machine off.
3) Check if the connection between the 1st HCF pick up drive and HCF board is correct.
4) If the connection is OK, replace the 1st HCF pick up drive unit.
5) If the problem persists, check the following.
a) Remove the 1st HCF pick up unit.
b) Check if the pick up sensor is contaminated, clean it.
c) If the pick up sensor is defective, replace it.
Copyright© 1995-2013 SAMSUNG. All rights reserved.
4. Troubleshooting
4-117

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multixpress m437x series

Table of Contents