Samsung MultiXpress M537x series Service Manual page 270

Mono laser mfp
Hide thumbs Also See for MultiXpress M537x series:
Table of Contents

Advertisement

4. Troubleshooting
f) Replace the Finisher main control board(JC81–07242A).
4) Is the Feed Entrance Motor (M1) working?
a) Check if the connector(JR10 8320) of the Feed entrance motor is disconnected.
b) Check if the connector(JR10 8320) J5 on the Finisher main board(JC81–07242A) is disconnected.
c) Check if there is continuity in the harness, and if not replace the harness (JR10 8320), replace as is necessary.
d) Replace the Feed entrance motor(M1).
e) Replace the Finisher main control board(JC81–07242A).
5) Check if there is any object on finisher paper path. Remove it if there is.
4-134
Copyright© 1995-2013 SAMSUNG. All rights reserved.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multixpress m437x series

Table of Contents