Table of Contents
Advertisement
Air recirculation on/off button (G)
The air recirculation is managed according to the
following operating logics:
❒ override on (inside air recirculation always on),
indicated by the LED on button G and the
symbol on the display;
❒ override off (air recirculation constantly off with
air intake from the outside), signalled by the LED
in the button switching off and by the
the display disappearing.
These operating conditions are obtained by pressing
air recirculation button G in sequence.
IMPORTANT The engagement of the air
recirculation system makes it possible to reach the
required heating or cooling conditions faster.
It is however not advisable to use recirculation on
rainy/cold days as it would considerably increase the
possibility of the windows steaming up, especially
if the climate control compressor is off.
The recirculation is forced off (air is introduced from
the outside) when the outside temperature is cold
to prevent misting.
It is advisable not to use the air recirculation function
when the outside temperature is low, because the
windows could rapidly steam up.
Climate control compressor enablement/off
button (F)
Press the
compressor off (if on). The icon on the display will
switch off.
Press the button when the LED is off to restore
automatic system control and use of the compressor.
The icon will light up on the display in this case.
The system will switch the recirculation off when the
symbol in
compressor is switched off to prevent the windows
misting up. Although the system is capable of
maintaining the required temperature, the word
FULL will disappear from the display. If, on the other
hand, it is no longer capable of maintaining the
temperature, the letters flash and the word AUTO
goes out.
IMPORTANT With the compressor off, it is not
possible to introduce air cooler than ambient
temperature into the passenger compartment.
Furthermore, in certain conditions, the windows
could mist up rapidly because the air is not
dehumidified.
The system remembers that the compressor has
been switched off, even after the engine has stopped.
To restore automatic compressor control, press
the √ button again (in this case, the system will only
work as a heater) or press the AUTO button.
With the compressor switched off, if the outside
temperature is higher than the one set, the system is
not capable of satisfying this request.
button to switch the climate control
KNOW YOUR
VEHICLE
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
57
Advertisement
Table of Contents
