Table of Contents
Advertisement
Installation diagram for Van versions fig. 164
KNOW YOUR
The tow hook structure must be fastened in the
VEHICLE
points shown by the symbol Ø using a total of 6
M10x1.25 screws and 4 M12 screws.
The internal back plates must be at least 5 mm thick.
SAFETY
MAX LOAD ON BALL: 100/120 kg according to
the payload (see "Weights" table in the "Technical
data" section).
STARTING AND
DRIVING
After fitting, screw holes must be sealed
to prevent a exhaust gas inlet.
WARNING LIGHTS
AND MESSAGES
To install a tow hook, the bumpers must be trimmed
as described in the supplier's installation kit.
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
162
WARNING
Installation diagram for Truck and Chassis Cab
versions fig. 165
Another tow hook specific to Truck and Chassis Cab
versions in shown in fig. 165.
The structure Ø must be fixed in the points
indicated using a total of 6 M10x1.25 screws and 4
M12 screws.
MAX LOAD ON BALL: 100/120 kg according to the
payload (see "Weights" table in the "Technical data"
section).
WARNING
After fitting, the screw holes must be
sealed to prevent exhaust gas from
entering.
Advertisement
Table of Contents
