Table of Contents
Advertisement
INFLATION PROCEDURE
KNOW YOUR
VEHICLE
Put on the protective gloves provided
together with quick tyre repair kit.
SAFETY
❒ Pull up the handbrake. Unscrew the tyre valve cap,
take out the flexible filler pipe A fig. 182 and
STARTING AND
tighten the ring nut B on the tyre valve;
DRIVING
❒ insert the plug E fig. 184 in the nearest 12 V power
socket and start the engine. Turn the selector D
fig. 183 anticlockwise to the repair position.
WARNING LIGHTS
Activate the kit by pressing the on/off switch.
AND MESSAGES
Inflate the tyre to the pressure specified in the
"Inflation pressure" paragraph, in the "Technical
Data" chapter;
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
fig. 182
192
WARNING
F0N0826
For a more accurate reading, it is advisable to check
the pressure reading on the pressure gauge F fig. 183
with the compressor off and without moving the
centre selector from the repair position;
❒ if after 10 minutes it is still impossible to reach at
least 3 bar, release the transparent filler pipe from
the valve and take out the 12 V plug, then move
the vehicle forwards by about 10 metres in order
to distribute the sealing fluid inside the tyre evenly,
then repeat the inflation operation;
❒ if after this operation you still cannot reach at least
3 bar after 10 minutes, do not resume driving
because the tyre is too damaged and the quick
tyre repair kit cannot guarantee suitable sealing.
Contact a Fiat Dealership;
❒ if the tyre reaches the pressure specified in
"Inflation pressure" paragraph in the "Technical
Data" section, start driving immediately;
fig. 183
F0N0827
Advertisement
Table of Contents
