UCM6102 IP PBX
DID/Extensions
To provision phones and assign extensions, navigate to PBX4Basic/Call Routes4
Extensions and click Create New User. Here the basic settings for a phone can
be configured. Under General, the Extension field specifies the extension for the
phone. CallerID Number and CallerID Name will be the DID number that will be
mapped to this extension. Permission is the permission level the user will have for
outgoing calls. Internal was used for all extensions. Under Technology check SIP.
Under SIP Settings enter the user's DID next to AuthID and set DTMF Mode to
Inband as shown. All other settings can be configured according to preference.
Note: DTMF tone duration cannot be configured on the PBX.
When done click Save then Apply Changes from above.
The devices can also use Auto Provisioning where the PBX will discover a device
upon boot up, automatically assign it an extension, and return a URL of the config file
for the device to download.
To do this, from Basic/Call Routes navigate to Zero Config and click
Auto Provision Settings. Once here check Enable Zero Config. Check
Automatically Assign Extension and specify the beginning extension next to
Start extension. A default password can also be set next to Default Password.
V 1.4
9