Operating Your Radio - Dab - Roberts Rambler Manual

Operating your radio - DAB

1. Carefully extend the telescopic aerial. The aerial should be fully
extended and positioned vertically for optimum reception.
2. Press and release the On/Off button to switch on your radio. After
each use the radio will remember the mode used and then switch on
in that mode the next time that it is used.
3. If this is the fi rst time the radio is used a scan of the Band III DAB
channels will be carried out. This is known as 'Auto tune'. If the radio
has been used before the last used station will be selected.
4. During Auto tune each group of stations will be detected and the
station count will be updated.
5. When the Auto tune is completed the fi rst station (in numeric-alpha
order 0...9...A....Z) will be selected. The fi rst station in the list of stations
found will be played.
6. If no stations are found then 'OFF AIR' will be displayed and it may be
necessary to relocate your radio to a position giving better reception.
You should then carry out an auto tune to fi nd stations as described
on page 9 (see Finding new stations on page 9).
• Your radio has an indicator
of the DAB radio signal being received.
Note: When fi rst switched on, the radio will set the volume to a moderately
high level, in case the broadcast is very quiet. After you have set the
volume, the radio will remember the setting that you have applied for the
next time that it is used.
on the display to indicate the strength
2
6