Operating Your Radio - Dab - Roberts Revival mini Manual

Operating your radio - DAB

1. Carefully extend the telescopic aerial fully.
2. Press and release the On/Off control to switch on your radio. The
display will show 'Welcome to DAB'. When first switched on, the radio
will be in DAB mode. After each use the radio will remember the mode
used and then switch on in that mode the next time that it is used.
3. If this is the first time the radio is used a scan of the Band III DAB
channels will be carried out. If the radio has been used before the last
used station will be selected.
4. During the scanning process, the lower line of the display shows a
bar-graph indicating progress of the scan.
5. When the scanning is completed the first station (in numeric-alpha
order 0...9...A....Z) will be selected. The first station in the list of stations
found during scanning will be played. The display will show the station
name.
6. If the station list is still empty after the scan your radio will display
'Service not available'.
7. If no signals are found it may be necessary to relocate your radio to
a position giving better reception. Then, either switch your radio off
and on again, or press and release the Auto Tune button to repeat
the scan.
7
2