Print Adjust - Oki B412dn User Manual

ECO MODE ON
CLRABLE ONLINE
WARNING
AUTO OFF
CONTINUE
MANUAL 60 SEC
TIMEOUT
TIMEOUT 40 SEC
INJOB
TIMEOUT 40 SEC
LOCAL
TIMEOUT 90 SEC
NET
LOW TONER CONTINUE
JAM ON
RECOVERY
ERROR OFF
REPORT
HEX DUMP -

PRINT ADJUST

Item
POSITION MP X
ADJUST TRAY ADJUST
Y
ADJUST
DUPLEX
X
ADJUST
DUPLEX
Y
ADJUST
TRAY1 X
ADJUST
Y
ADJUST
DUPLEX
X
ADJUST
DUPLEX
Y
ADJUST
TRAY2 X
ADJUST
Y
ADJUST
DUPLEX
X
ADJUST
DUPLEX
Y
ADJUST
PAPER BLACK SET
DARKNESS
SMR SETTING
If set to [ON]: In the case of making a small number of prints, printing starts even when the fuser
has not reached the specified temperature.
If set to [OFF]: Printing starts when the fuser reaches the specified temperature.
Sets the timing to remove the display of warnings that can be cleared.
Sets whether to automatically recover the printer when a memory overflow occurs.
Sets the time in seconds that it takes for the printer to cancel a job in paper feed waiting state
when printing with manual feed.
Sets the printer's wait time (seconds) from the stoppage of data processing to the outputting of
the pages.
Sets the time to keep the ports open after a process is complete. (excluding network)
Sets the time to keep the network port open after a process is complete.
Sets the printer action to be taken when toner is low.
Sets whether to retry the printing of pages that were not printed due to paper jam after the paper
jam is cleared.
Sets whether to print an error report when an internal error occurs.
Prints data received from the host computer in hex dump. To end printing, turn off the printer.
Factory default Description
setting
0.00 MILLIMETER
X correction: Corrects the position of the whole print image in the direction
perpendicular to the paper feed direction.
Available range: ±2.00 mm (in units of 0.25 mm)
0.00 MILLIMETER
Y correction: Corrects the position of the whole print image in the paper feed
direction.
0.00 MILLIMETER
Available range: ±2.00 mm (in units of 0.25 mm)
Duplex printing X correction: Corrects the position of the print image in the
direction perpendicular to the paper feed direction when printing the back side of
0.00 MILLIMETER
the duplex prints.
Available range: ±2.00 mm (in units of 0.25 mm)
0.00 MILLIMETER
Duplex printing Y correction: Corrects the position of the print image in the paper
feed direction when printing the back side of the duplex prints.
Available range: ±2.00 mm (in units of 0.25 mm)
0.00 MILLIMETER
0.00 MILLIMETER
0.00 MILLIMETER
0.00 MILLIMETER
0.00 MILLIMETER
0.00 MILLIMETER
0.00 MILLIMETER
0 Corrects the variation in print that is caused by temperature difference. Change the
value when blurring occurs.
0 Sets the print density.
0 Corrects the variation in print results that is caused by temperature and humidity
conditions, as well as differences in print density and the frequency of printing.
289