Select Ring (And Ringer Volume); Self-Test - AT&T Definity 7410 User Manual

Select Ring (and Ringer Volume)

To select a
personalized ring
To adjust ringer volume
if necessary

Self-Test

To test the lights and
ringer of your voice
terminal
1 While on-hook, press [
Green light goes on steadily
2 Press [
Conference/Ring
Green light next to [
pattern plays and repeats every 4 seconds
3 Continue to press [
Conference/Ring
8 ring patterns
4 When you hear the desired ring pattern, press
[ ] again
Select
Your new ring is set; green light next to [
goes off
Note: If you receive a call, go off-hook, or lose power
during selection, process is interrupted and you must
start again. If you lose power after you have selected
your personalized ring, you will have to select your
ring pattern again.
1 To raise the volume, press the right half of the
Volume control button labeled [
to lower the volume, press the left half of the
Volume control button labeled [
(There are 8 possible volume settings.)
1 While on-hook, press [
Green light goes on steadily
2 Press and hold [
Drop/Test
Ringer sounds; all lights go on steadily
3 Release [
] to end test
Drop/Test
Ringer and lights return to pretest state; green
light next to [
Select
Note: If ringer or lights do not respond during test,
notify your System Manager.
]
Select
]
] winks; current ring
Select
] to cycle through all
Select
] ;
]
]
Select
]
] also goes off
]
1 7