AT&T Definity 7410 User Manual page 11

To program/reprogram an
outside number,
extension, or feature code
into a personal list
To place a call using a
personal, group, system,
or enhanced list
1 On a separate sheet of paper, jot down the outside
numbers, extensions, and/or feature codes you want to
program as items on your personal list(s) (see example
to the left)
Note: Each phone number or feature code is stored
as a separate item.
2 Pick up handset
3 Press [ ]
Program
or Dial Program code
Dial Personal List number (1, 2, or 3)
4
5 Dial list item (1, 2, 3...)
6 Dial number you want to program (up to 24 digits)
Note: If you are programming an outside number, be
sure to include a trunk code, if applicable.
7 Press [ # ]
Number is stored
Repeat Steps 5-7 if you want to program
additional items on the same list; press [
and begin again at Step 1 if you want to program
items on another list
8 Hang up or press [
Drop/Test
Note: Record your personal list items on the
Abbreviated Dialing list in the back of this booklet;
group, system, and enhanced lists can be obtained
from the System Manager.
1 Dial appropriate AD list code:
List 1
List 2
List 3
2 Dial desired list item (1, 2, 3...)
Call is dialed
Note: You can program a list code on one of your
AD buttons for quicker access to a list. To place a
call, simply press the AD button and then dial the
desired list item.
[dial tone]
[dial tone]
[dial tone]
[dial tone]
[confirmation tone], [dial tone]
Drop/Test
] to end programming
[dial tone]
]
8