Adjusting The Dmx Start Address - Look Solutions Viper 2.6 Operating Manual

You may control the Viper 2.6 externally through the XLR sockets [8 and 10].
Please note: DMX takes priority. That means: when the machine is controlled
via DMX 512 this data takes priority over 0-10 V (+) DC and Stand alone operation.
5.4.2 Operating via DMX 512
Connecting the Viper 2.6 to a DMX-desk using the 5pin XLR socket [8] on the
back of the machine. As soon as the machine receives a correct DMX signal, the
yellow DMX-LED [19] shines.
Now the pump and the fan can be adjusted via the desk.
Please note: If a fan is connected to the machine, the Viper 2.6 uses two channels
at your desk. Channel 1 = Pump, Channel 2 = Fan.

5.4.2.1 Adjusting the DMX start address

a) Press the Mode-button [16] at the control panel, until three figures will appear
on the LED display [20].
b) Adjust the requested start address by pressing the Up/Down-buttons [17].
c) Save the start address by pressing the Enter-button [18] once. The start address
will also be saved when you disconnect the machine from the mains supply.
5.4.3 0 - 10 Volt (+) DC control
Connect the Viper 2.6 to an analog desk or to the cable remote (available as an
optional extra), using the 3pin XLR socket [10] at the back of the machine.
Please note: With analog control the pump can be adjusted from the desk and/
or the cable remote. The fan has to be adjusted directly at the machine.
a) Connect the cable from the desk or the cable remote into the 3pin XLR socket
at the back of the machine [10].
b) The knob on the cable remote or the fader on the analog desk will control the
level of the pump.
c) Pressing the On/Off switch at the cable remote starts the fog process.
To adjust the fan output
a) press the Mode-button [16] until a „F" and two figures appear on the display
[20].
b) Adjust the fan output with the Up/Down-buttons [17].
5. Operating the Viper 2.6
12