Troubleshooting - Outback Omega 100 Assembly And Operating Instructions Manual

L. Troubleshooting
Problem
Burner will not light using the
ignition system
Burner will not light with a match LP gas cylinder is empty
Low flame or flashback (fire in
burner tube— a hissing or roar-
ing noise may be heard)
Gas valve knob difficult to turn
Possible Cause
LP gas cylinder is empty
Faulty regulator
Obstructions in burner
Obstructions in gas jets or gas hose
Electrode wire is loose or disconnected on
electrode or ignition unit.
Electrode or wire is damaged
Faulty pushbutton ignitor
Faulty regulator
Obstructions in burner
Obstructions in gas jets or gas hose
LP gas cylinder too small
Obstructions in burner
Obstructions in gas jets or gas hose
Windy conditions.
Gas valve jammed
For reference and correspondence, record
your serial number here.
(See sticker on side of barbecue body.)
Serial No.
__________________
This number may be
ordering spare parts or accessories. A part
reference number may also be required
where applicable.
22
Solution
Replace with full cylinder
Have regulator checked or replaced
Clean burner
Clean jets and gas hose
Reconnect wire
Change electrode and wire
Change ignitor
Replace with full cylinder
Have regulator checked or replaced
Clean burner
Clean jets and gas hose
Use larger cylinder.
Clean burner
Clean jets and gas hose
Use BBQ in a more sheltered position
Replace gas valve
required when
Published December 2007