Rs-232 - Atlona AT-UHD-SW-52ED User Manual

IP Commands
Command
IPCFG
IPQuit
IPAddUser X Y
Ex. IPAddUser Atlona 1234
IPAddUser
IPDelUser X
IPDHCP X
IPStatic X Y Z
Ex. IPStatic 192.168.1.1
255.255.255.0
192.168.1.200
IPPort X
IPLogin X
Ex. IPLogin off
Broadcast X
Ex. Broadcast on
IPTimeout XX
Ex. IPTimeout 300
Each command or feedback is terminated with a carriage return.
Note: If the command fails or is incorrect the feedback is "Command FAILED"
Baud Rate
Default baud rate to control the switcher is 115200 and default baud rate to control the display or projector
is 9600.
Note: For the display's actual baud rate, refer to the owner's manual
To change the baud rate of the switcher (for switcher control) or the zone output (for display/projector
control), the commands below will be needed
Switcher baud command
CSpara[baudrate,data-length,parity,stop-bit]
Example: To change the baud rate to 38400 use CSpara[38400,8,0,1]
Note: Use this command if the connected control system does not output 115200
Zone output baud commands
RS232para1[baudrate,data-length,parity,stop-bit]
Example: To change the output baud rate to 19200 use RS232para1[19200,8,0,1]
Note: Use this command if the connected display uses a different baud rate
RS232zone1[command]
Once the switcher and zone output have been set up for the best communication, commands can be sent
to control the display. The commands will come from the user manual of the display or projector. The com-
mands and any carriage returns/line feeds in the commands will need to be placed in the bracket.
Example: To turn the display or projector on if the command is PWRON carriage return, use the command:
RS232zone1[PWRON carriage return]
atlona.com
Feedback
IP Addr : x.x.x.x
Netmask : x.x.x.x
Gateway : x.x.x.x
IP Port : x
IPQuit
TCP/IP user was added
username password
username password
username password
TCP/IP user was deleted
IPDHCP X
IPStatic X Y Z
Ex. IPStatic 192.168.1.1
255.255.255.0
192.168.1.200
IPPort X
IPLogin X
Ex. IPLogin off
Broadcast X
Ex. Broadcast on
IPTimeout XX
Ex. IPTimeout300
(data-length, parity, and stop-bit for switcher must be 8,0,1)
(for display control)
Description
Displays IP address configuration
Logs out of TCP/IP Connection
Adds a user for TCP/IP control
X= user and Y= Password
Displays a list of users and passwords
Delete a user from TCP/IP X= username
Turns HDCP on or off X= on, off, sta
Sets static IP address
IPStatic Address(X) Netmask(Y) Gateway(Z)
Set the TCP/IP Port
Enables IP Login
X= on, off, sta
Sets broadcast mode on or off
X= on, off, sta
Determines amount of seconds of inactivity before TCP/IP
disconnects
16
Toll free: 1-877-536-3976
Local: 1-408-962-0515