Installation; Rs-232 / Ir Connector - Atlona AT-JUNO-451-HDBT Manual

Installation

The AT-JUNO-451-HDBT provides RS-232 and IR control, using the included four-pin captive screw connector.
Electrical IR or RS-232 signals, from a control system, can be used to control the AT-JUNO-451-HDBT. Atlona
recommends the AT-LC-CS-IR-2M (sold separately) for easy connection to the captive screw connector.
1. Use wire strippers to remove a portion of the cable jacket.
2. Remove at least 3/16" (5 mm) of insulation, from the end of each wire.
3. Insert the wires into the correct terminal on the included captive screw block, as shown below.
4. Tighten the screws to secure the wires. Do not use high-torque devices as this may damage the screws and/or
connector block.
The illustration below, shows an example of how electrical IR or RS-232, from a control system, or the included IR
remote, can be used to control the AT-JUNO-451-HDBT.
AT-JUNO-451-HDBT

RS-232 / IR Connector

Control System
4
3
2
1
ET
ETH ERN
L
ITA L T
DIG AX OU IN
CO R AUD IO
ENT
ON OU T
CO MP IO
AUD
MI
HD
OU T
EO
VID
1
IAL
SER
5
3
6 IAL 2
1 SER
TOR Y 4
FAC ET
RES 2
IR OU T
DC
48V
2
TX
RX
GND
S
GND
D BT
51 -H
O -4
JU N
A T-
FW
T
IN PU
W ER
PO
4
T
IN PU
3
2
1
X TM
U N O
J
SW-51 IR Remote Control
(included)
to control system
or AT-VCC-IR-KIT
11