Table of Contents
Advertisement
WWW.SEAGULLMODELS.COM
810mm.
810mm.
820 mm
M2 clevis.
M2 clevis.
M2 lock nut.
M2 lock nut.
Elevator pushrod.
Elevator pushrod.
RUDDER PUSHROD HORN
INSTALLATION.
Rudder control horn
810mm.
.
810 mm
M2 clevis.
M2 clevis.
M2 lock nut.
M2 lock nut.
840 mm
INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot and
canopy.
.
2) A scale pilot is included with this ARF.
The Seagull Pilot included fitting well
to the cockpit. (or you can order others
scale pilot figures made by Seagull fac-
tory. They are available at Seagull factory.
They are available at Seagull distributors.)
If you are going to install a pilot figure,
please use a sanding bar to sand the base of
the figure so that it is flat.
3) Position the pilot figure on the canopy
floor as show. Locate the oval shaped on the
canopy floor and remove the covering. Use
epoxy to glue this into the base of the pilot
figure and glue the cockpit panel in place
with C/A glue, please see pictures as shown.
Rudder pushrod.
23
Advertisement
Table of Contents
