Hangar 9 Advance 40 Instruction Manual page 10

Stage 1—Assembling the Wing
Step 9. Install the Z-bend of one of the aileron linkages into the
outermost hole in the aileron servo arm as shown.
Note: It may fit tightly and therefore be necessary to work the
Z-bend back and forth until it inserts freely.
Now install the other aileron linkage on the opposite side using
the same procedure as above. Once installed, move the linkages
back and forth a few times until they move freely.
When both aileron linkages are attached, center the servo so the
servo arm is parallel to the wing's leading edge and trailing edge.
Step 10. We will now be fitting the clevis into the aileron
connectors on the toque rods. At this point, it may be necessary
to adjust the length of the aileron linkage so the ailerons are
10
aligned with the trailing edge of the wing surface. To adjust the
length of the aileron linkage, simply turn the black clevis in or
out until, when connected, the aileron is level with the wing. It
may be necessary to adjust both linkages.
If the aileron is lower than the trailing edge, the linkage needs to
be shortened and vice versa.
Note: Place a piece of the provided fuel tubing over the clevis of
each linkage to prevent the clevis from opening.
Congratulations—you have just
completed the wing!
CONTINUED