Stage 6-Installing The Engine - Hangar 9 Advance 40 Instruction Manual

Stage 6—Installing the Engine
Parts Needed
• .40 - .48 size 2-cycle engine with muffler or .50 - .56 size
4-stroke engine with muffler
• Engine mount with mounting hardware (the mounting
hardware is pre-installed on the engine mount)
Step 1. On the front of the Advance 40 is the pre-attached
engine mount (HAN40M). Unscrew the engine mounting
hardware (engine clamp bolts and clamps) from the engine
mount. Retain the hardware as we'll be using it to mount the
engine in place.
• Fuselage assembly
• Fuel tubing piece (5mm) (1)
Place the engine on the engine mount and loosely clamp the
engine in place using the provided mounting hardware.
Note: The knurled (checkered) side of the clamps faces
down, and it's a good idea to use thread lock on the
bolts before installing the nuts.
Slide the engine as far forward as it will go and center the
engine, then tighten the screws until they become snug.
Note: Be sure the screws that hold the clamp over the engine
mounting lugs are tightened very securely.
Fuel tubing
23