Jensen JiLS-525iB User Manual page 16

Re-linking to the cell phone
If your cell phone or Bluetooth device is already paired with the JiLS-525iB, but became
unlinked at some point, even with both Bluetooth devices turned on. You can re-link them by:
1. Press and hold the PAIR button on remote control or
re-link your cell phone. The "PAIR" message will appear in LED display and then "bt"
message flashing for about 10 minutes.
2. Select JiLS-525iB on your cell phone for linking. Display message will change to show
"bt" steadily for few seconds and then change to show current time if the JiLS-525iB
and your cell phone have been re-linked successfully.
3. You can also re-link the JiLS-525iB by using Bluetooth operation of your cell phone.
Please refer to operation manual of your cell phone for more information.
This unit features an Aux-in Jack (auxiliary input) for connecting an external audio device like
an MP3 player, CD player and older, non-dockable iPods (except 3rd generation iPod shuffle)
and listening to the audio from that device through the docking speakers.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on both ends.
2. Plug one end of the cable into the AUX-IN Jack on the back of the main unit and the other
end into the Line-out Jack or Headphone Jack of your external audio device.
3. Turn on the external audio device.
4. Tap the button to turn on the unit.
5. To select auxiliary audio input, tap the FUNCTION button. The "AU" indicator will display
few seconds.
6. The output volume can now be controlled using the VOLUME + or VOLUME – buttons on
the remote and main unit. Operate all other functions on the auxiliary device as usual.
Note:
If the Line Out Jack of your external device is connected, then you only need to adjust
the volume control of this unit. If the Headphone Jack of your external device is connected,
then you may need to adjust both the volume control of your external device and the
volume control of this unit to obtain the most comfortable volume level.
Press and hold the Power
forget to switch off the power of your external device as well.
ENERGY SAVING NOTE
In AUX-In mode, if no audio signal (music) is detected at the AUX-IN input after around 10
minutes, the unit will turn off (standby mode) automatically.
BLUETOOTH OPERATION
USING THE AUXILIARY INPUT (AUX-IN)
button to turn off the system when you finish listening. Don't
/PAIR button on main unit to
14