Location Of Controls; Radio Operations - Jensen JiMS 220 - Docking Digital Music System Owner's Manual

Rear view
24. Headphone Jack
25. BACKLIGHT Dimmer ---- Select LCD back-lit Dim/Bright.
26. FM Antenna wire
27. AUX IN ---- An audio signal input cable with a 3.5mm
stereo plug for the connection of external audio device.
28. RESET ---- For resetting the unit.
29. Battery Compartment ---- Located at bottom of the unit.
30. DC IN Jack ---- To connect to external DC power supply
29 26 27 28 25 24 30

LOCATION OF CONTROLS

Remote Control
1. Infra-red Transmitter
1
2. POWER On/Off
3. SLEEP button - Select sleep timer duration
4. FUNCTION button - Select AM/FM radio, iPod, CD and AUX mode
SLEEP POWER
3 2
ON/OFF 5. P-MODE button - Select CD play mode
4
6 6. MODE button - Enter the setting mode
FUNC P-MODE MODE
5
7. BAND button - Selects AM / FM radio band
9
7
BAND
8. STOP button - Stop CD playback
8
TUN +
CH+
FF 9. PLAY/PAUSE
10 12
VOLUME
CH TUN 10. CH+/- button - Select preset radio station
FR
11
11. TUNE + /FF and TUNE - /FR button
13
MEM PGM MUTE 15
14
Tune the radio channel frequency up or down;
16
EQ
LIGHT ON/OFF 18
Skip forward or skip backward in iPod, CD mode
SNOOZE ALARM
17
12. VOLUME + / - button - Adjust volume level up and down
13. MEM button -Save radio preset station
14. PGM button - Set CD program
15. MUTE button - Mute volume
19
16. SNOOZE/LIGHT button - Activate the snooze functio, turn LCD
backlight ON / OFF
17. EQ button - Select equalizer (EQ) effect
18. ALARM ON/OFF button - Turn the alarm on and off
19. Battery Compartment
button
button - Play or pause playback of CD or iPod
9

RADIO OPERATIONS

FM Antenna
Unwrap and fully extend the FM Antenna wire for best FM radio reception.
Radio Tuning
1. Press POWER button to turn on the unit.
2. Press the FUNCTION button to select radio mode.
Press BAND button to select AM / FM radio band, if necessary.
3.To manually tune to desired station, repeatedly press the
4.To automatically search for stations with strong signals, press and hold the
button until the frequency digits on display begins to scan then release the button. The tuner will stop on
the first strong station signal it finds.
Notes:
• Manual tune to select weaker stations that might be by passed during automatic tuning.
• If the automatic tuning does not stop on the exact frequency of the station,
for example, it stops on 100.9 MHz instead of 100.8 MHz, use the manual tuning method to "fine tune"
to the exact frequency of the desired station.
• In FM mode, you may press the MODE button to select FM stereo or mono receiving mode, if necessary.
Radio Preset Stations
The unit allows you to store up to 10 AM and 10 FM stations for easy recall at any time.
Manual Preset
1. Press POWER button to turn on the unit.
2. Press the FUNCTION button to select radio mode.
Press BAND button to select AM / FM radio band, if necessary.
3. Tune to the radio station you want to store in memory using the
4. Press the MEM button. The preset channel number "01" appears on display.
5. To select desired preset station number, press CH + / - button.
6. To confirm preset location, press the MEM button.
7. To store up to 10 AM and 10 FM station presets, repeat steps 3 to 6 above.
Tips for the Best Reception
To obtain the best AM reception, slightly rotate the unit until the clearest signal is recrived or place it near
outdoor.
To obtain the best FM reception, fully extend the FM Antenna and adjust its direction.
NOTE: The iPod may cause interference to the AM reception if it is docked and turned ON.
You should turn off the iPod manually or remove it
10
/ TUNE- or / TUNE + button.
/ TUNE- or / TUNE +
/ TUNE- or / TUNE + button.
from the unit for better reception.