Max HN100(CE) Operating And Maintenance Manual page 13

CONTACT TIP
Contact Arm
Contact Tip
WARNING
ALWAYS disconnect air supply before
attaching / detaching the contact tip.
Attach the Contact Tip on the tip of Contact Arm,
when driving nails to a soft material.
The Contact Tip can be kept on the Contact Tip
holder when not using.
HOW TO REMOVE PLASTIC SHEET
As nails are driven the plastic sheet will feed out
of the tool. When sufficient strip has been fed out
it can be torn away by pulling against the rear
edge in the nose.
Contact Tip holder
13
HOW TO REMOVE JAMMING OF NAILS
Hammer
Punch
WARNING
When removing jamming of nails, be sure to
lock the trigger prior to disconnecting the air
hose.
PROCEDURE
q Lock the trigger and disconnect the air hose.
w Remove the nails out of the magazine.
e Open the door, put a punch through the
discharge outlet and hit it with a hammer.
r Remove the nails jamming inside the nose or
contact nose using the punch or a regular
screwdriver.
t Set the nails properly onto the feed pawl again
and close the door.
ENGLISH
Regular screwdriver