Max HN100(CE) Operating And Maintenance Manual page 12

ENGLISH
DRIVING FASTENERS
CONTACT FIRE OPERATION
(CONTACT TRIP)
For contact fire operation, hold the trigger and
depress the contact arm against the work surface.
1
2
PROCEDURE
q Hold the trigger.
w Depress the contact arm.
SINGLE FIRE OPERATION
(ANTI-DOUBLE FIRE MECHANISM AND
SEQUENTIAL TRIP)
For single fire operation, depress the contact arm
against the work surface and pull the trigger. Tool
can not fire a second fastener until the trigger is
released and tool can cycle.
2
1
PROCEDURE
q Depress the contact arm.
w Pull the trigger.
ADJUSTABLE DIAL DEPTH CONTROL
Adjustment Dial
Deeper Shallow
WARNING
ALWAYS disconnect air supply before dial
adjustment.
q With air pressure set, drive nails into a
representative material sample to determine if
adjustment is necessary.
w If adjustment is required, disconnect air
supply.
e Refer to the mark on the Adjust Spacer for
direction to turn the adjustment dial.
r Reconnect air supply.
TRIGGER LOCK MECHANISM
Trigger lock dial
The tool is equipped with a trigger lock
mechanism. Push and rotate the trigger LOCK to
the trigger UNLOCK position before driving nails.
12
Contact Arm
Trigger