Downrod-Style Fan Mounting - Harbor Breeze DUBOIS DM52BCP5CS Installation Manual

INITIAL INSTALLATION
4. Secure mounting bracket (C) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting bracket (C)
as this will support the fan.
IMPORTANT: If using the angle mount, make sure
open end of mounting bracket (C) is installed facing
the higher point of the ceiling.
5. Remove motor screws (K) and lock washers (L)
from underside of motor housing (D). Set aside for
later use. [If there are plastic motor blocks installed
with the motor screws (K) and lock washers (L),
discard the plastic motor blocks.]
For DOWNROD-STYLE FAN MOUNTING, proceed
to step 1 below. For CLOSEMOUNT-STYLE FAN
MOUNTING, skip to page 10.

DOWNROD-STYLE FAN MOUNTING

1.
Remove pin (N) and clip (O) from yoke at the top of
motor housing (D) and partially loosen
preassembled set screws and nuts.
4 4
Standard Mount
C
5
Plastic
Motor
Block
1
O
Yoke
D
Lowes.com/harborbreeze
7
Angle Mount
C
Open End
K J
K
L
D
Set
Screws
and Nuts
N