Manual Release Operation; Manual Release Latching; Manual Operation - Centurion D10 Installation Manual

6. Ped:
7. Trg:
8. Light:
n1 = number of cores required by intercom
n2 = number of cores required by intercom
Possibly increase cable thickness if pillar lights are installed
Type of cable must adhere to municipal bylaws but typically SWA
(steel wire armoured) cable is recommended. The armouring
provides excellent screening, which gives better protection against
lightning – earth one end of the screening)
Allows for all features such as pedestrian opening, status LED, etc.,
to be operated from the intercom handset inside the dwelling.
Number of cores and type of cable could vary depending on brand
of access control system being used
For optimum range, an external receiver can be mounted on the
wall

10. Manual Operation

Manual Release
operation
In the event of a power
failure, or product
malfunction, it may be
required to lock the cover
in place whilst 'latching'
the Manual Release (i.e.
Manual Release
permanently enabled).
This helps prevent theft of
the unit, or its
components, and provides
full protection from the
elements
1. Manual Release handle in
closed position.
2. Open lock cover and insert
key. Turn the key a quarter-
turn, counter-clockwise to
unlock.
3. Pull the Manual Release
handle down to enable
Manual Release.
Manual Release
latching
Now that the Manual Release is
enabled, you may follow the
process below to lock the cover in
place.
4. With the release handle
lowered, insert the split pin,
(supplied with the mounting
hardware kit), through the
hole in the gearbox as
indicated.
5. Make sure that the split pin
goes all the way in as
shown.
6. Raise handle and then turn
key a quarter-turn clockwise
to lock. Remove key and
close lock.
Optional Pedestrian Keyswitch (a) or keypad
(b)
(3 core 0.5mm )
Optional external radio receiver
Optional Pillar Lights
to power requirements)
2
(3 core LNE SWA, size according
2
(3 core 0.5mm )