Disassembly - Pride Mobility Jet 12 Owner's Manual

V I I .
Your Jet 12 is a folding power chair. Once you remove the two battery boxes, you can fold the chair for easy
transportation or storage. See figure 31.
WARNING! You must make sure that the frame lock bar is locked in the down position before
placing the battery boxes onto the frame. Failure to do so could cause the power chair to become
unstable.
To disassemble your Jet 12:
1. Disconnect the 9-pin controller connector and the charger connector. See figure 22.
2. Place the Jet 12 in freewheel mode. See figures 27 and 28.
3. Disconnect the front battery box. See figure 24.
4. Lift the front battery box off of the power base.
5. Disconnect the rear battery box. See figure 22. If the “P” clip is installed, remove the controller from
the armrest. (See “P” clip accessory kit).
6. Lift the rear battery box up and off the power base.
7. Locate the frame lock on the front of the chair. Unhook the frame lock and rotate it up. See figure 32.
8. Grab the seat rails and pull up.
Figure 31. Jet 12 - Disassembled and Folded
24
D I S A S S E M B L Y
Figure 32. Front of Jet 12
www.pridemobility.com
FRAME LOCK (MUST BE LOCKED IN THE DOWN POSITION
BEFORE INSTALLING THE BATTERY BOXES)
Jet12/RevC/Feb03