Disassembly And Assembly - Pride Mobility Vista Owner's Manual

I X . D I S A S S E M B L Y A N D A S S E M B L Y
The Vista requires no tools for disassembly. Always disassemble or assemble your Vista on a level, dry surface
with sufficient room for you to work and move around your scooter. Keep in mind that the disassembled sections
of the Vista will take up more floor space than the assembled Vista.
DISASSEMBLY
1. Remove the key from the key switch. See V. “Your
Vista.”
2. Pull up on the manual freewheel lever. See V. “Your
Vista.” Putting your Vista in freewheel may make it
easier for you to maneuver the rear section because the
drive wheels are free to turn.
3. Make certain that the seat is locked into position. See
VIII. “ Comfort Adjustments.” Lift the seat up and off
of your Vista.
4. Gently lift the rear shroud off of your Vista. The rear
shroud is held in place with a reusable fastener.
5. Unplug both 2-pin battery harnesses. See figure 13.
6. Loosen the battery straps then lift both batteries from
the battery wells.
CAUTION! Failing to unplug both battery
harnesses and the front-to-rear connector
prior to further disassembly could result in
permanent damage to your Vista.
7. Unplug the large, white, 9-pin front-to-rear connector
that attaches the front control console assembly har-
ness to the electronic controller module harness. See
figure 14.
8. Turn the tiller adjustment lever counterclockwise until it
is loose. Pull the rubber boot upward to expose the
tiller release buttons. With one hand on the rear of the
tiller, carefully depress both tiller release buttons while
slowly lowering the tiller to the center of the floorboard.
See figure 8A.
9. Remove the ball detent pin from the frame. See figure
15.
10. Move the cam locks to the unlocked, vertical position.
See figure 15.
11. With one hand on the seat pedestal and one hand on
the front frame handle, gently slide the front and rear
sections apart. See figure 16.
32
UNPLUG HERE
FIGURE 13. BATTERY HARNESS CONNECTORS
UNPLUG HERE
FIGURE 14. FRONT-TO-REAR CONNECTOR
FIGURE 15. FRAME CAM LOCK LEVERS
UNLOCKED POSITION
REMOVE THIS PIN
Vista