Cleaning Instructions - Pride Mobility Jet 12 Owner's Manual

X . C A R E
n Check the rear forks for damage or fluttering, which indicates that they may need to be adjusted or that
the bearings may need to be replaced. See your authorized Pride provider for repair or replacement.
n Keep your Jet 12 clean and free of foreign material such as hair, food, and drink residue, etc.
YEARLY CHECKS
Take your Jet 12 to your authorized Pride provider for yearly maintenance. This will help ensure that your
Jet 12 is functioning properly and help prevent future complications.
STORAGE
Your power chair should be stored in a dry place not subject to temperature extremes. When storing,
disconnect the batteries from the Jet 12. See VIII. “Batteries and Charging” for complete instructions.
CAUTION! If you fail to store the unit properly, the frame can rust and the electronics can
be damaged.

CLEANING INSTRUCTIONS

CAUTION! Never hose off your Jet 12 or place it in direct contact with water. Your Jet 12
has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a
damp cloth.
CAUTION! Never use any chemicals to clean a vinyl seat, as they may cause the seat to
become slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
TIRES
Your Jet 12 is equipped with solid tires. You should check them at least once per week. This will prolong
the life of your tires as well as help ensure the perfect operation of your chair. If you have a cut tire, replace
it. Replacement wheels are readily available at your authorized Pride provider.
WARNING! To avoid possible injury,
be sure that the controller’s power is
turned off and the power chair is not
in freewheel mode before performing
this procedure.
Follow these easy steps for a quick and safe
tire replacement:
1. Place a support under the motor.
2. Use a 4-mm hex key to remove the five hex
head screws that fasten the hubcap and remove
the hubcap. See figure 34.
3. Use a 17-mm socket to remove the nut and
washer from wheel axle.
4. Pull the wheel off of the axle.
5. Remove the old wheel and replace it with a
new wheel.
32
A N D M A I N T E N A N C E
MOTOR BRUSH
CAP LOCATION
Figure 34. Drive Wheel and Motor Brush Location
www.pridemobility.com
REMOVE 4MM SCREWS TO ACCESS
17-MM DRIVE WHEEL NUT.
Jet12/RevC/Feb03