Pride Mobility Jet 12 Owner's Manual page 34

X . C A R E A N D M A I N T E N A N C E
To inspect or replace the motor brushes:
1. Remove the battery cases.
2. Unscrew the motor brush caps. See figure 34.
3. Remove the brushes.
4. Inspect the brushes for wear.
5. Replace the brushes if necessary. Contact your authorized Pride provider for replacement brushes.
CORRECTIVE MAINTENANCE
If the battery condition meter does not light up:
n Check the harness connections. Make sure they are tight.
n Check the circuit breaker. Reset it if necessary.
n Check the battery connections.
If the above checks prove normal, you can load test the batteries with a battery load tester. These testers are
available at automotive parts stores. Disconnect both batteries before load testing and follow the directions
that came with the load tester. If either one of the battery fails the load test, replace both of them. If your Jet
12 still does not power up, contact your authorized Pride provider.
WHEN TO SEE YOUR AUTHORIZED PRIDE PROVIDER FOR SERVICE
The following symptoms could indicate a serious problem with your Jet 12. If necessary, contact your
authorized Pride provider. When calling, have ready the model number, the serial number, the nature of the
problem, and the trouble code if available.
n Motor noise
n Frayed harnesses
n Cracked or broken connectors
n Uneven wear on any of the tires
n Jerky motion
n Pulling to one side
n Bent or broken wheel assemblies
n Does not power up
n Powers up, but does not move
34 www.pridemobility.com Jet12/RevC/Feb03