Table of Contents
Advertisement
Installing the inverter
General
IMPORTANT! Depending on the surface, different wall anchors and screws may be re-
quired for installing the wall bracket. These wall anchors and screws are not part of the
scope of delivery for the inverter. The installer is responsible for selecting the proper wall
anchors and screws.
Assembling the
1
1
wall bracket
Recommended
In most cases, you should use 1/4 in. or 5/16 in. stainless steel or aluminum screws capa-
screws for wall
ble of supporting:
bracket assembly
-
-
-
Attaching the wall
IMPORTANT! Keep a minimum distance under the inverter corresponding to the 'NEC
bracket - mount-
110.26 for code compliant disconnect location. If the DC disconnect is to be code compli-
ing height
ant, it must be readily accessible (NEC 690.14 (B) (1)).
The DC disconnect is in the lower left part of the inverter. Also, the cut out segment marked
(*) in the following drawings represents the placement of the inverter display. Use this to
ensure a comfortable display height for easy reading.
26
NOTE! The inverter is designed only for a vertical installation position.
"click"
"click"
31 lbs. for Fronius IG Plus 3.0-1 / 3.8-1
57 lbs. for Fronius IG Plus 5.0-1 / 6.0-1 / 7.5-1
82 lbs. for Fronius IG Plus 10.0-1 / 10.0-3 / 11.4-1 / 11.4-3 / 12.0-3
1
1
Advertisement
Table of Contents
